Reflecta 10T
Verfasst: Sonntag 25. November 2018, 03:43
First post and its a question, I apologise for that.
I have an Imacon 848 and a V800 so hopefully, I can contribute elsewhere!!
So, several years ago I had a Reflecta Proscan 7200, sold it when I found my Imacon, was a mistake as it was a solid workhorse that produced good scans. In order to take some workload off the Imacon I have just bought a Reflecta 10T.
Just set it up this morning, the first couple of scans and I have an issue, something is seriously out of alignment.
The obvious answer is to return it as it's new. The issue with that is I bought it in the UK and it's now living in NZ.....so, question - Has anyone ever opened one of these up, I'm thinking there must be a fairly rudimentary way to adjust the housing inside???
Cheers, Jason.
I have an Imacon 848 and a V800 so hopefully, I can contribute elsewhere!!
So, several years ago I had a Reflecta Proscan 7200, sold it when I found my Imacon, was a mistake as it was a solid workhorse that produced good scans. In order to take some workload off the Imacon I have just bought a Reflecta 10T.
Just set it up this morning, the first couple of scans and I have an issue, something is seriously out of alignment.
The obvious answer is to return it as it's new. The issue with that is I bought it in the UK and it's now living in NZ.....so, question - Has anyone ever opened one of these up, I'm thinking there must be a fairly rudimentary way to adjust the housing inside???
Cheers, Jason.